Method 1: Install AnyDesk on Ubuntu using terminal It is covered here because it is available on Linux and the article’s focus is on Linux. ![]() If Anydesk must be installed (or re-installed) on a PC where Rangecast software has already been loaded, you can use an Anydesk install script that is included as part of the Rangecast software.AnyDesk is not open source software. Installing Anydesk on a PC where Rangecast software has already been loadedĪnydesk is remote desktop software used by Rangecast to access PCs. After this is done, you can re-run the Anydesk installation script to get a new ID (and send Rangecast the ID that is generated by the software.) If the PC has already been cloned, deleting nf from the indicated folder is likely sufficient to clear the old ID. Use this technique to deploy/rollout images of your OS with AnyDesk pre-installed:ĭelete the nf file in: %programdata%\AnyDesk. In this way both machines will have a unique ID. The following instructions are from the Anydesk website (as of April 2019) and describe how this is done.Ĭloned systems have the same ID, which makes it impossible to connect to both of them.ĭelete the nf on one of these systems and restart AnyDesk to get a new ID. This can be done by erasing a specific configuration file from the PC, and then re-running the Anydesk installation script. This is a problem, since it will only be possible to contact one of the PCs remotely (and there is no control over which PC.) Therefore, in this situation, it is necessary to clear the Anydesk ID from some/all of the PCs. If cloning PCs with Anydesk installed, each of the clones will have the same Anydesk ID as the original PC. Clearing the Anydesk ID (for cloned PCs to allow generation of a fresh ID)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |